The problem 2FA cannot generate QR code. Click on 'Generate TwoFactor Secret Key' and jump to the root page. Output of ./validate.php =========================================== Component | Version --------- | ------- LibreNMS | 23.1.0-19-gaa033ec3c (2023-02-02T05:07:59-08:00) DB Schema | 2022_09_0...

The problem I recently upgraded my installation to 23.1.0, which required a php upgrade from 7.4 to 8.1. Since then, the discovery-protocols part was failing: [2023-01-31T13:03:53.996958+01:00] production.ERROR: Error discovering discovery-protocols module for <<device>>. TypeError: Can...

The problem I install libreNMS with docker at my Mac as development environment. I found that test-transport is not working with only add an alert transport. Might I think is right, it just print the hard coded words "This is a test alert". It shouldn't be any dependency of other component. http://l...

The problem The Raisecom RAX721 switches are relatively new models running major version 6 of Raisecom ROS. It turns out that some SNMP tables like all IF-MIB tables but also Q-BRIDGE-MIB tables don't have increasing OIDs in an snmpwalk. For example: $ snmpwalk -v2c -M $HOME/.snmp/mibs:/usr/share/sn...

The problem when try to see ports on any CISCO SW, get NGINX 500 timeout...in december was working! Output of ./validate.php valdation ok! What was the last working version of LibreNMS? latest Anything in the logs that might be useful for us? No response

The problem For some reason some of my port data disappears from LibreNMS and is added back a minute later. I'm not sure why this is happening (a device issue, no doubt). That's not a problem in and of itself. However, the traffic graphs show a huge spike the minute it's added back. Would it be poss...

The problem Hello all I'm noticing reporting problems for the USW-24-POE (latest firmware 6.4.18). It's a new device; Before recommending it to the customer we tried monitoring with a US-8-60W which is monitoring totally fine, assuming it would be the same for this model. I notice a different in pla...

The problem The sensor is alerting because there is no fiber connected to the switch port that has a transceiver in it. I have to disable monitoring on all these dBm sensors to clear the alert which is misleading. Is it possible to add check to this sensor to make sure that the port in question is a...

The problem Hello, Since we've updated ou server from php7.4 to php8.1 and execute daily.sh to get librenms up to date, the polling doesn't work if influxdb poller is enabled. When influxdb poller enabled, errors shows in the log: [2023-01-10T09:41:25.384449+01:00] production.ERROR: Cannot access of...

The problem Different ports on this device flapped, however Alert log only shows the most recent Alert's fault info. Output of ./validate.php [[email protected] ~]$ ./validate.php =========================================== Component | Version --------- | ------- LibreNMS | 22.12.0 (2022-12-28T18...